Home  »  Products  »  WiFi  »  OUTDOOR WI-FI ACCESS POINTS

OUTDOOR WI-FI ACCESS POINTS (MODEL: STN–TWI 1040–PE)



Telenet’s TWI series of 802.11b/g/n compliant 2.4GHz Wireless LAN products feature 1x1 and 1x2 MIMO antennas. Future versions will have 4x4 MIMO and more. These come in various form factors – For Outdoor applications, For an indoor AP/Router. These can be configured as AP / Station. It can operate in Point-to-Point and Point-to-Multi-Point links. It can be configured in WDS mode as well.

It can be available with Wireless WAN and Wireless LAN capabilities as well. The TWI series has a high performance radio output and advanced networking and management capabilities. It can support NAT Routing, DHCP server, DHCP relay, DHCP with option 60/82,QoS, Security based on WPA2/WPA/WEP, Rate Limiting, Broadcast Storm control, etc.

For different applications suitable antenna is provided with appropriate gains. It could have a Omni antenna, Directional antenna as per the requirement of the deployment. The Antenna can have single polarization or multipolarization, with V/H or Cross Polar.

The housings are built according to the applications, such as indoor housing and outdoor housing with ruggedized
weatherproof design to meet various IP classes of protection.

GENERAL
General Standard
IEEE 802.11b/g/n WLAN, IEEE 802.3/802.3u Ethernet IEEE 802.11e QoS
Ethernet Interface
Four auto MDX, auto sensing 10/100 Mbps, RJ45 port
Operation modes
Station WDS Bridge
QoS
WMM
Certification
FCC Compliant
SYSTEM
CPU
180 Mhz or better
Flash / SDRAM
4 / 8 MB
NETWORKING
Networking
DHCP client, Configurable DHCP option 60
Test
PING function and Trace Route function
VLAN
VLAN Support; Management VLAN
ROUTER FEATURE
Networking
Static route, NAT/PAT, DMZ, DHCP Client/Server/Relay, DNS Proxy, DDNS
VPN
PPTP/L2TP/IPSec pass-through Pass through
RADIO
Number of Radio
One 802.11 b/g/n Radio
Frequency Range
2400 - 2490Mhz
Channel Number
ETSI 1-13
Channel Bandwidth
Narrow Bandwidth 20 / 40 MHz Support ; Auto in STA mode
RF transmission power
20dBM
Receiver Sensitivity
-94 dBm
ANTENNA
Internal Antenna gain
8dBi
Internal Antenna3 dB Beamwidth
65 Degrees / 65 Degrees
Internal Antenna Polarization
Horizontal Polarization
MANAGEMENT
NMS

CENTRALISED WEB BASED MANAGEMENT SYSTEM for Monitoring,Configuration and Software Upgrade
Management – Device

HTTP& HTTPS Web-based GUI, Telnet Management, button for factory reset,
SNMP

SNMP V1 & V2, SNMP traps for RSSI / Signal Quality Degradation, Interference , Congestion , Packet Drop
Firmware Upgrade

Automated centralized Firmware Upgrade &WebUI manual upgrade ; Keep setting when Firmware Upgrade
LED indication
Power, Ethernet , Wireless signal strength
ETHERNET INTERFACE -SPECIFICATION
Ethernet Connectors

RJ-45 Jacks, 4 Ports 10/100 Base-TX with Auto-MDIX 4-Ports PoE PD (Data+Power IN) – For powering of device
Standards


IEEE Std.802.2 10BASE-T 10Mbps,Half/Full Duplex; IEEE Std.802.23u 100BASE-TX,10/100Mbps, Half/Full Duplex;IEEE Std.802.3x Flow control and Back-pressure.
Surge Protection
Protection against initial ESD/EFT Transient Suppression
Protocols
CSMA/CD
Power Over Ethernet Injector: Power Supply(IN) for CPE.
Power over Ethernet 12V, 1A (12 Watts) on Spare pair to supply power to the CPE
No. of Ethernet Ports that can Power ON the CPE.
Anyone/All of the four LAN ports

Max Packet size supported
1536 bytes
Port Isolation
Using Port-based VLAN
Support Broadcast Storm control per port
Yes
SECURITY
Wireless Security



WEP, WPA2 - PSK(TKIP/AES)
WPA2-AES with 802.1x (for Metro LAN mode)
802.1x Supplicant EAP-TTLS
MSCHAPV2 EAP-TLS, EAP-TTLS and PEAP support
POWER
Power options
100-270 V 50/60 Hz, Indian PIN type Powering through POE DC power
Power Method
Passive Power over Ethernet
Max Power Consumption
4 Watts
Power Supply
12V, 1A (12 Watts). Power Supply andPOE injector included
PHYSICAL
Physical Dimension/ Form factor
Compact and easily mountable
Enclosure Size
175 x 168 x 52 mm
Weight
<500 g
Operating temperature
(0 to 50 deg cent) Outdoor Temprature
Humidity
5 to 90% Condensing
ENVIRONMENT PROTECTION
Compliances
WEEE,RoHS
Shock and Vibration
ETSI300-0110-1.4
Protection

Dust Protected , Protected from Spray Water upto 60 Degree from V , 50 cm Drop Test
Enclosure Characteristics
Outdoor UV Stabilized Plastic